
Page 6
Pyramid Universal Dome Interface Installation Manual
CONNECTING AND CONFIGURING THE UDI
The two end panels of the Universal Dome Interface contain all the connectors and switches that are required to
connect and configure the device. The panels also contain a number of receive and transmit LEDs which enable easy
system diagnosis, and a service pin that is used when the UDI is addressed.
DOME DATA
Tx
Rx
SERVICEDOME SELECTION12V DC
24V AC
1
2
3
4
5
Dome Data End Panel of the UDI
1234
PYRAMID DATABIAS
ALARM I/P
11234C
+
-
T
NO
NC
Tx
Rx
6
7
8
9
Pyramid Data End Panel of the UDI
Power Connection - Connect the power supply to this 2-pin removable terminal block. This can be any +12V
DC or 24V AC power supply capable of providing 100mA. The connection is polarity insensitive.
Dome Selection Dip Switches - It is necessary to set these dip switches so that the UDI knows which dome
camera product is to be connected. The UDI is compatible with domes manufactured by Baxall, AD/Sensormatic,
Dennard, JVC, Mark Mercer, Panasonic, Pelco, Ultrak, Vicon, Vista and VCL. Baxall CDR and CDH cameras
are also supported.
Consult the table below in order to set the dome selection dip switches for the product in use. The UDI will
need to be powered off, then powered on again if a different protocol is selected.
Komentáře k této Příručce