Pyramid DC Receiver Instalační manuál stáhnout pdf (Strana 15)

Page 15

Installation Manual Pyramid Universal Dome Interface

CONNECTING A VISTA DOME CAMERA

To connect a Vista dome camera to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Remove the dome from the mounting bracket to expose the connectors.

2. Connect the wire from the UDIs Dome Data Connector, using the diagram below as a guide:

Connecting a Vista PowerDome to the UDI

3. Refit the dome camera to the mounting bracket.

4. The dip switches on the camera can be accessed without removing the camera from the casing. Set dip switch

number 1 to ON and all others to OFF, as shown below:

Configuring an Vista PowerDome

CONNECTING A BAXALL CDR OR CDH CAMERA

To connect a Baxall CDR or CDH camera to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a CDR or CDH camera, reference should also be made to documentation provided

with the camera.

1. Connect the D-type Comms I/O Connector on the rear of the camera to the wire from the UDIs Dome Data

Connector. Use the diagram below to connect to pins 1, 2 and 5 of the Comms I/O Connector:

Connecting a CDH or CDR Camera to the UDI

2. Referring to the relevant camera manual, use the camera menu system to set the communication protocol to

Baxall, the baud rate to 9600 and the camera address to 00001.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Žádné komentáře

Pyramid DC Receiver Instalační manuál Strana 15