Pyramid DC Receiver Provozní pokyny stáhnout pdf (Strana 7)

Page 7

Installation and Operating Instructions Pyramid DC Receiver

CONNECTIONS

NETWORK

Network cards come pre-fitted to your Pyramid DC Receiver and in normal circumstances there will be no need to disconect the network

card. If you need to remove or refit a network card, proceed as follows.

CAUTIO

To avoid damaging your module switch off the power before fitting the network card

Switch off the power, fit a network card in the position indicated on figure 1. Connection details for the network card are

included on the sheet provided with the network card.

POWER CONECTIONS

WARNING

Ensure that the power is switched off before connecting the mains wires.

Your PY-DCW module must be earthed.

If you are using mains, connect the Live, Earth and Neutral wires from the mains supply to Live, Earth and Neutral on the

terminal block fitted to the baseplate.

Check that all the wiring is correct and switch on the 24V DC power and the power supply for your auxiliaries.

WARNING

YOUR DC RECEIVER PCB MAY NOW CONTAIN LIVE VOLTAGES

TESTING

Your DC receiver has an on board test procedure which steps through the outputs in the sequence shown in table 1. The

test push button is shown in figure 1. The test takes 55 seconds.

WARNING

YOUR DC RECEIVER PCB CONTAINS LIVE VOLTAGES

CAUTIO

Ensure that the mechanical endstops are set before running the test routine. This will prevent the P/T head crashing.

Press the test push button with an appropriate tool

Step Action Time Step Action Time

1 Right and Down 5s 13 Pause 2s

2 Pause 2s 14 Zoom Out 3s

3 Pan Left 3s 15 Zoom In 3s

4 Pause 1s 16 Pause 2s

5 Pan Right 3s 17 Iris Close 3s

6 Pause 2s 18 Iris Open 3s

7 Tilt Up 3s 19 Pause 2s

8 Pause 1s 20 AUX A 2 s

9 Tilt Down 3s 21 AUX B 2s

10 Pause 2s 22 AUX C 2s

11 Focus Near 3s 23 AUX D 2s

12 Focus Far 3s 24 Exit

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

Pyramid DC Receiver Provozní pokyny Strana 7